Alat Pemantau dan Penghitung Jumlah Pengunjung Berbasis Aplikasi Telegram
Abstract
A visitor monitoring and counting device is a tool designed to send information in the form of images and the number of visitors detected through a camera and sensors installed on the device. This device is based on the Telegram application using the ESP32-CAM module as the camera to capture images of each incoming visitor. The device is equipped with an infrared sensor used to detect incoming visitors. The device works by counting the number of visitors when they enter, and then sending a signal to the ESP32-CAM to capture a physical image as evidence. The data from the device's operation is sent through the Telegram application. The research results show that the device functions well at a distance of 60 cm, but it does not function properly at a distance of 90 cm. The average time required for the device to send an image to the application is 2.5 seconds. The fastest time required by the system to read data between one visitor and the next is 15,4 seconds.
References
[2] W. Indah Kusumawati, H. Pratikno, and Y. Pradeska Admaja, “Sistem Penghitung Jumlah Pengunjung Restoran Menggunakan Kamera Berbasis Single Shot Detector (SSD),” Journal of Technology and Informatics (JoTI), vol. 3, no. 1, 2021, doi: 10.37802/joti.v3i1.197.
[3] P. Arri Ape Pane Basabilik Prodi Fisika, J. Fisika, and U. Tanjungpura, “Rancang Bangun Sistem Pemantau Kedatangan Tamu Berbasis Internet Of Things (Iot),” PRISMA FISIKA, vol. 9, no. 2, pp. 110–116, 2021, [Online]. Available: https://jurnal.untan.ac.id/index.php/jpfu/article/view/49316
[4] A. A. Sari, I. F. Rahmad, and F. Tambunan, “Perancangan Dan Implementasi System Pendeteksi Pengunjung Pada Toko Berbasis Arduino,” Jurnal Mahasiswa Fakultas Teknik dan Ilmu Komputer, vol. 1, no. 1, 2020.
[5] N. Palinggi, N. A. Aziz, D. Kambuno, and ..., “Alat Monitoring Pengunjung Mall dengan Standar Covid-19 Berbasis Arduino,” … Teknik Elektro dan …, no. September, 2021.
[6] D. Intan Surya Saputra, “Rancang Bangun Alat Penghitung Jumlah Pengunjung di Toko Adhelina Berbasis Mikrokontroler Atmega 16,” Jurnal Sisfokom (Sistem Informasi dan Komputer), vol. 4, no. 1, 2015, doi: 10.32736/sisfokom.v4i1.131.
[7] E. S. Budi, “Perancangan Alat Penghitung Jumlah Pengunjung Konser Berbasis Mikrokontroler At89s51,” Jurnal Media Informatika Budidarma, vol. 2, no. 3, 2018, doi: 10.30865/mib.v2i3.658.
[8] M. Fahmawaty and M. Royhan, “Perancangan Alat Penghitung Jumlah Pengunjung Di Perpustakaan Unis Tangerang Menggunakan Sensor Pir Berbasis IoT,” JIMTEK : Jurnal Ilmiah Fakultas Teknik, vol. 1, no. 3, 2020.
[9] A. K. Paring, Bambang Supradono, “Rancang Bangun Alat Penghitung Pengunjung Perpustakaan Dengan Microcontroler AT89S51 Dengan Penampil LCD,” Media Elektrika, Vol. 4 No. 1, Juni 2011, vol. 4, no. 1, 2018.
[10] Almuttaqin and M. Nasir, “Rancang Bangun Alat Penghitung Jumlah Pengunjung Di Perpustakaan Politeknik Negeri Bengkalis Berbasis Mikrokontroler,” in Seminar Nasional Industri dan Teknologi (SNIT), 2021.
[11] M. Idhom, A. Fauzi, R. Alit, and H. E. Wahanani, “Implementation System Telegram Bot for Monitoring Linux Server,” 2018. doi: 10.2991/icst-18.2018.219.
[12] Y. P. Atmojo, “Bot Alert Snort dengan Telegram Bot API pada Intrusion Detection System: Studi Kasus IDS pada Server Web,” Proceeding Seminar Nasional Sistem Informasi dan Teknologi Informasi, vol. 12, no. 1, pp. 176–180, 2018, [Online]. Available: https://api.telegram.org/bot$apiToken/sendMessage
[13] A. D. Mulyanto, “Pemanfaatan Bot Telegram Untuk Media Informasi Penelitian,” MATICS, vol. 12, no. 1, p. 49, Apr. 2020, doi: 10.18860/mat.v12i1.8847.
[14] S. Jupri, D. Hendryadi, N. Syam, S. Komputer, and S. Bina Adinata, “Pengembangan Alat Penghitung Jumlah Pengunjung Wisata Permandian Eremerasa Berbasis Arduino,” JTRISTE, vol. 8, no. 2, pp. 23–31, 2021.
[15] G. D. Fadhillah, A. P. Kharisma, and T. Afirianto, “Pengembangan RestoCrowd: Aplikasi Android Penghitung Jumlah Pengunjung Restoran Berbasis Crowdsourcing dengan Ekstrapolasi,” … Teknologi Informasi dan Ilmu …, vol. 4, no. 4. 2020.
[16] O. Berezhnoj et al., “Methods and Tools of Video Monitoring for Remote Laboratory,” in 2022 IEEE European Technology and Engineering Management Summit, E-TEMS 2022 - Conference Proceedings, 2022. doi: 10.1109/E-TEMS53558.2022.9944406.
[17] M. Babiuch, P. Foltynek, and P. Smutny, “Using the ESP32 microcontroller for data processing,” in Proceedings of the 2019 20th International Carpathian Control Conference, ICCC 2019, 2019. doi: 10.1109/CarpathianCC.2019.8765944.
[18] A. Setiawan and A. I. Purnamasari, “Pengembangan Smart Home Dengan Microcontrollers ESP32 Dan MC-38 Meningkatkan Deteksi Dini Keamanan Perumahan,” Jurnal RESTI (Rekayasa Sistem dan Teknologi Informasi), vol. 3, no. 3, pp. 451–457, 2019.
[19] D. K. Hakim and S. A. Nugroho, “Implementasi Telegram Bot untuk Monitoring Mikrotik Router,” Sainteks, vol. 16, no. 2, 2020, doi: 10.30595/st.v16i2.7132.
Manuscript submission
Submission of a manuscript to the Journal of Applied Electrical Engineering (JAEE) implies that the work described has not been published before (except in the form of an abstract or as part of a published lecture, review or thesis); that it is not under consideration for publication elsewhere; that its publication has been approved by all co-authors, if any, as well as tacitly or explicitly by responsible authorities at the institution where the work was carried out.
The author warrants that his/her contribution is original and that he/she has full power to make this grant. The author signs for and accepts responsibility for releasing this material on behalf of any and all co-authors. The author affirms that the article contains no unfounded or unlawful statements and does not violate the rights of others. If copyrighted works are included, the author bears responsibility to obtain written permission from the copyright owners and to appropriately credit the sources.
The use of general descriptive names, trade names, trademarks, etc. in the publication, even if not specifically identified, does not imply that these names are not protected by the relavant laws and regulation.
Copyright Transfer Agreement
The Copyright Transfer Agreement must be signed and return to the publisher of JAEE before manuscript can be accepted for publication. The Transfer of copyright to JAEE becomes effective if and when the article is accepted for publication. if the submitted manuscript is not accepted by Journal, all rights will returned to the authors of the work.
All articles published in JAEE are protect by copyright, which cover the exclusive and unlimited rights to reproduce and distribute the article in any form of reproduction (printing, electronic media or any other form), as well as the translation rights for all languages and countries, for the full term (including extensions and renewals). No material published in the JAEE may be reproduced photographically or store on microfilm, in electronic databases, video disk, etc., without first obtaining written permission from the publisher.
Author's rights
The author may send or transmit individual copies of the final published version of his/her manuscripts any format, including the PDF, to colleagues upon their specific request provided no fee is charged, and further-provided that there is no systematic distribution of the manuscript, e.g. posting on a listserve, website or automatic delivery. However posting the article on a secure network, not accessible to the public, is permitted.
For other purposes, e.g. publication on his/her own website, the author must use the original author-created version of his/her article, i.e. the original submitted file prior to review. He/she may not use the publisher's PDF version. Furthermore, the author may only post his/her version provided acknowledgement is given to the original source of publication and a link (DOI) is inserted to the published article on the JAEE website. The link must be accompanied by the following text: 'The original publication is available at <insert website link here>'.
The author(s) retain all proprietary rights, other than copyright, such as patent and trademark rights to any process or procedure described in the article. The author(s) have the right to photocopy the article for their own personal use.
An author has the right to use (part of) his/her article in subsequent publication of the authors own works provided that written permission is obtained from the publisher and that proper acknowledgement is made to the original source of publication and the publisher. Any other use or reproduction in a collective work requires a fee and permission from the publisher.
The right to grant or refuse permission to third parties to republish part of the article or translations thereof. However, the publisher except at the direction of the contributor(s) will not refuse such permission.
Warrant
While the information in the JAEE is believed to be true and accurate at the date of its publication, neither the authors, the editors, nor the publisher can accept any legal responsibility for any errors or omissions that may be made. The publisher makes no warranty, express or implied, with respect to material contained herein.
